Department of DefenseIssuing agency·Redstone Arsenal, AL·via the SAM.gov Get Opportunities APIWe post new it & software opportunities in Alabama as agencies publish them. Get them in one email — free, and unsubscribe whenever.
The Prototype Integration Facility (PIF), Combat Capabilities Development Command (DEVCOM) Aviation and Missile Center, Redstone Arsenal, Alabama, has a requirement to procure a Torque Measurement System to interoperate with a Variable-Geometry, Radial Outflow Compressor (VAROC) Air Dynamometer 250 and T408 aircraft engine in support of Flexible Engine Diagnostics Systems (FEDS).
Description of Required Supplies/Services:
Description
V250 / T408 Torque Measurement System Kit
The contractor shall provide the following with the TMS Kits:
TMS Module / Shaft to engine components: spline adapter and splined hub, if necessary.
TMS Plumbing
TMS Calibration Kit with weights
Electronics: Signal processor, Rotastat Control and 90 ft. cable
V250 Application Study for the T408 Aircraft Engine
The contractor shall evaluate the V250 Dynamometer with respect to testing objectives and configuration needs for testing the GE T408 Turboshaft Engine. The contractor shall define the specific interphase requirements with consideration to test plans, including inertia requirements, speeds, and power.
The following are deliverables as a result of this application study:
Special Rotor consideration for inertia requirements
Identifying the torque measurement equipment, including but not limited to torque meter, interconnect shafts, and electronics.
Upon determining appropriate torque meter system, CN will update or generate new drawings and documents and enable life solutions.
The contractor shall provide a V250/T408 Torque Measurement System Kit including a TMS Module/Shaft with spline adapter and splined hub, TMS Plumbing, TMS Calibration Kit with weights, and electronics (signal processor, Rotastat Control, and 90 ft. cable). Additionally, the contractor shall conduct a V250 Application Study for the T408 Aircraft Engine, evaluating the V250 Dynamometer for testing the GE T408 Turboshaft Engine, defining interface requirements including inertia, speeds, and power, and delivering special rotor considerations, identification of torque measurement equipment, and updated drawings and documents.
Source: SAM.gov (notice 1382ddf28b4043f693446ab0ceba574b), retrieved via the SAM.gov Get Opportunities API. View the official posting , always confirm requirements and deadlines with the issuing agency.
